Lzb Ending

Discussion in 'TSW General Discussion' started by jampot317, Aug 21, 2020.

  1. jampot317

    jampot317 New Member

    Joined:
    Jul 16, 2020
    Messages:
    13
    Likes Received:
    4
    Hey, I was driving from Köln to Aachen and was nearing the end of the LZB controlled section when the "ending" icon appeared in the bottom right of the hud. Although I tried to press b to dismiss this warning but the emergency brakes and a constant warning horn were engaged. Just wanted to know if there is a way to dismiss this ending warning or if I have to turn off LZB from the fuse cabinet before reaching the end, thanks!
    Btw, I was using the immersive controller layout.
     
    • Helpful Helpful x 1
  2. Captaintraincrash

    Captaintraincrash Active Member

    Joined:
    Apr 4, 2020
    Messages:
    167
    Likes Received:
    153
    B is the classic control layout for Safety system acknowledge I don't know about the immersive layout
     
  3. jampot317

    jampot317 New Member

    Joined:
    Jul 16, 2020
    Messages:
    13
    Likes Received:
    4
    Okay, thank you, I'll have a look at the different control layouts
     
    • Like Like x 1
  4. Bob12212

    Bob12212 Well-Known Member

    Joined:
    Sep 17, 2018
    Messages:
    485
    Likes Received:
    340
    Hi!

    You need to press PZB release to acknowledge this, it will then release you from LZB without penalty
     
    • Helpful Helpful x 2
  5. Bob12212

    Bob12212 Well-Known Member

    Joined:
    Sep 17, 2018
    Messages:
    485
    Likes Received:
    340
    Sorry, I think I replied to a post further down rather than this one for you. Press PZB release, this will stop the penalty break and allow you come out of LZB and bsck into PZB monitoring
     
  6. jampot317

    jampot317 New Member

    Joined:
    Jul 16, 2020
    Messages:
    13
    Likes Received:
    4
    Ohhh probably should have tried that, thanks a lot
     
  7. jampot317

    jampot317 New Member

    Joined:
    Jul 16, 2020
    Messages:
    13
    Likes Received:
    4
    Ahhh, thanks very much for your help
     
  8. xD 2Bad4You

    xD 2Bad4You Well-Known Member

    Joined:
    Mar 10, 2018
    Messages:
    1,002
    Likes Received:
    822
    To get out of the LZB when the "Ende" starts flashing you have to press "PZB Frei" to acknowledge it.
    After you have done this it stops flashing and has a solid light. When it goes off you hear a "beep" and you have to maintain Control following the PZB rules on your own again.
    With a Keyboad, press the "End" button or aim to the middle pzb control with the Controller and press it.
     

Share This Page