PlayStation Sand Patch Ac4400cw Glitch

This for the AC4400CW Introduction When trying to enter the Engineer Main Screen view the game doesn't recognise that I've done this. Therefore I cant progress any further

The picture attached is as far as I can get.

 

I've done this recently, it worked. You'll have to change the controller setup from immersion to classic, then press R3 and select the Engineer Main Screen. Just using the zoom with the immersion setup doesn't do the trick.
But you're right, that's a bug, and DTG does know about it.

 

this is a known bug. Here's a work around:
First of all, before you enter the tutorial, while still in the menu, make sure that your controls are in 'immersion' (settings / controls). If not, change it to immersion before you enter the tutorial.
Once in the tutorial, pause the game, go to settings and select classic controls. Continue the tutorial. Now when you get asked to go into Engineer main screen, push R3, select Engineer main screen, and now the game will recognise you're in the correct screen.

 

How do you do the coal llading one as it won't let me change it. To classic how do I do the same

 

This happens if you didn't start the tutorial with the immersion controls, so make sure you always switch back.

 

So how do I make it work. Im zo confused

 

So badly want to do the coal one

 

Just follow the steps OnlyMe1909 posted above for each of these two tutorials you mentioned.