OK so there's a few. I am on Xbox, but these issues might also be elsewhere... 1) Unable to take screen shots 'in cab' or 'from cab' of locos in CJP. Oakville works fine. Worked fine pre-patch. 2) Unable to paint handrails on SD40-2 in Livery Designer (CJP version). Does not over-layer at all. Have tried many times. Yes I know the technique - it's not working for the SD40-2s. 3) Camera issue of not recognizing "return to first person" in Oakville Introduction causing dead service and return to main menu. No work around. See images... Returned to First person in this shot, but service does not recognize or continue. 4) Mirror indicator in way of view when going to external camera in CJP. Could be closer to loco body and not out in the driver's view. See Images... Where mirror indicator is when you go to outside view. Extent of mirror to outside of frame. Where mirror indicator should be set. 5) LS locks up becomes useless in Liver Designer not allowing panning of loco up, down, left, or right. Very annoying. Makes working on liveries tedious. Not my controllers, others have reported same malfunction on other platforms. 6) Need Bell shut off on X or D-pad like TSW2020. 7) Cameras and their controls in general are really messed up in Xbox. Switching cameras is a bizarre procedure and non specific. Bring back the old camera view selection pop up. It may have been tedious but at least it worked efficiently. 8) Custom LD rail car reskins do not spawn in CJP at all, but most do in Oakville randomly regardless of Timetable or regular service mode.. Only the locos can be used and seen via Timetable in CJP. Just thought this to be weird, and wondering what is going on with this whole custom thing if it isn't functioning as expected or advertised. If I find any others I'll add them to this thread.
This is also an issue on the Sherman Hill SD40-2 (basically the same model in TSW terms) and spoils the head-out view that I normally use for those locos.
