PS5 [resolved] Expert 101 Service Issues - Door Closing Objective Not Recognised

BELOW ISSUE IS RESOLVED CAN CONFIRM

Apparently this was user error and I was oblivious to my ZS aus light being on. The approach to Freilassing opened the MCB, so my next steps were to close the MCB and continue. I omitted the part where you’re supposed to start your electric train supply (hold it for a sec until to light goes off).

PS5 on Salzburg services 216 AND 218… after closing the doors at Traunstein, the barber pole stays green and never registers the next objective. Doors seem to work fine elsewhere. Not good, so far I can’t complete a service on that route.

 

Looks like I’m not the only one with an issue, someone else posted:

Question, why is it on console anyway the cab car nor the 101 registers a stop? I have to keep pressing door close and the instruction doesn’t clear. And it’s annoying. Even if I manually try to close the doors it still says “lock doors”

 

For me, the doors open and close, the game just doesn’t register them as either at Traunstein. I can sit there and play with the doors all day and nothing changes unfortunately

 

After discussing with folks in the discord… this is, in good probability, user error. Will test later and post results for anyone else having the issue.

If still having an issue, I’ll post a video

PS - thanks to DTG Chris for moving/merging all these threads around, appreciate you

 

Just want to +1 on a door issue. Pulled into Dresden Neustadt, pressed "Y" to open the left doors, and even though the orange timer started to show passengers being loaded, TSW was still saying "Unlock doors" and the door control on the desk wasn't moving. At the end of the loading, the circle went green but was still requesting me to unlock doors.

ZS has been on the whole of my run (apart from a fault which reset it while driving, but it was back on within a few seconds).

 

I thought the I had ZS on as well but I’m going to double check to make sure the ZS AUS light is definitely off. It could’ve lit back up after one of the neutral sections or something and maybe I forget to start it back up

This is my hunch anyway

 

So here’s what I’m finding (and I’m going to over explain, in case others need it, I certainty did)

Ok so there’s a neutral section, dead section right before we get to Freilassing (service 218). Obviously the MCB opens- but also important to note, the ZS aus light comes on the dashboard (center/left dash)

I had been closing the MCB, but forgetting to “start” the “electric train supply” (which is that little knob next to the MCB that you turn). Therefore I was departing Freilassing without the electric train supply and I guess slowly killing my power on the way to the next stop (Traunstein).

Haven’t gotten to Traunstein to finalize the test but pretty confident this was the cause. Will confirm in an edit.

 

Glad you've found a fix.

For me it's a different issue - ZS is 100% on, so hopefully I can find a way to recreate it to help the devs.

 

I'm still having this issue, specifically on Take a Cab back, but I believe it happened in Sweaty Palms as well. The fix above does not appear to work for me.

 

Hi,
I have exactly the same issue: how to finish the scenario ?