My question is this does anyone know how to fix the class 802 I’ve been encountering issues where it seems fine then get adverse signals then when clear to go train won’t move despite fact brake gauge shows brakes off tried all sorts inc full engine shutdown n master key on off but still can’t figure it out same happens in the sandbox mode also except on thst case train doesn’t move at all
I know I encountered a similar issue with the cucumber 802 when I put the DRA on at a red, only for the thing to then become unable to move even after I turned it off. Not even resetting physics fixed it and I had to abandon the run
Would you be able to send a video of this? what platform is this on? sounds similar to what the 220 was doing which there is a work around for : Basically, set cab A PBC to off, reverser off, and key out. Then head to the other cab, Key on, reverser forward, release brakes and apply a little power, you should move, bring the train back to a halt, PBC to off, reverser out, key out and go back to the cab you were in. Set the cab up as normal and you should be able to get a brake release.
Hi Jamie it’s series x I’ve checked brakes and everything been followed 10 second rule of holding engine start I’m baffled as spawned lner 801 in and works fine on diesel mode
