I am trying to create a scenario that involves driving the blunt end of the Class 91. I have the AP enhancement installed and know how to activate and deactivate the cabs by pressing CTRL plus the number 1 or 2 keys, but I'm not actually sure how I switch the camera view so that I am sitting in the blunt end. If I press CTRL plus + or - it will switch the view between the sloped ends of the cab at the front and back of the train, but not the blunt end. So, can anyone tell me how I can switch the view so I am sitting in the blunt end of the 91? Thanks
As you have read you can change ends of the Class 91 with the AP Pack But it does not change the cab designation in TSC If you attach the Sloped end to a set of stock it moves the number 2 view to the new back end of the train. Push 3 to get the outside view or 1 for the Cab view
Thanks for the help; however, I was able to figure it out. You have to press the left or right arrow keys to get the camera view to show inside the blunt end. Then, from there, you can press 1 or 3 to switch from the internal and external views of the loco in the front. Also, I noticed when in the blunt end of the cab, when you move the reverser handle to the forward position, on the HUD, it actually shows it as being in reverse. I take it this is a limitation of the sim, is that correct?
From the AP Manual When entering a cab that is inactive, there is a large inscription in the cab window, telling the driver to either press ‘Ctrl+1’ to activate the no.1 cab, or ‘Ctrl+2’ to activate the no.2 end cab. Doing this allows you to use the reverser as you would in reality, rather than the reverse logic which was present in the default set up. It might show reverse in the HUD but it does go Forward when you select that direction
Thanks I was able to figure it out. like I said I knew how to activate the cab I just didn't know how to actually enter the blunt end
