Trying to run the Class 31 with AWS enabled. But I immediately get a blue warning light on the dash and the train acts as if I didn't acknowledge. Brakes go on and power goes to 0. I can only seem to drive it if I isolate the AWS. I'd much prefer to run with it. What am I doing wrong?
Have you switched the Cab Changeover lever as well as the AWS isolator (together on the back wall of the cab)?
Interesting, I didn't know there was such a lever and it doesn't seem to get a mention in the Class 31 manual at all (I just had a quick look). Does the Cab Changeover lever only apply to AWS? I've successfully switched cabs before and didn't do it but then I haven't tried using AWS on the Class 31 yet.
Yes it is just for the AWS. It wouldn't surprise me if there's no mention in the manual. I found out about the lever by watching a youtube video of someone doing a service in the 37 and they used it when switching ends.
I always check for these things now after getting stuck with some of the Armstrong Powerhouse loco's in TS over the years. Taught me a lesson to read the manual and check for levers behind me.