Twice I have tried this scenario. Twice I had the same result. About 1 km or so out of Coswig I get stopped by a Pzb zwansbremsung and I have no idea why. I’m very used to pzb, so I like to think I know the system well. At that point sings and signals allow me to go 100 Kmh. Second time I even slow down to 80 and still got stopped. Any one had the same experience? Is this scenario bugged, or is there something I missed?
I had exactly the same experience. I was sure I hadn't missed anything but ended up doubting myself. The description for this run also mentions congestion, yet i didn't get a single restrictive aspect for the entire run.
I'll try again tomorrow evening. I'll reduce speed at that point to about 30 or 40. I have a suspision there's a sneeky 500hz magnet active...
Same here, I just restarted and turned PZB off. Getting tiring doing runs with PZB being broken now, routes are clearly not playtested before release with safety systems enabled.
I assume this is the same issue as detailed in this thread on the PC forum..? https://forums.dovetailgames.com/th...enario-forced-gpa-stop-after-hl-signal.45438/ As mentioned in that thread, you also get this problem on the fast Coswig services that use the single line bit. Slowing to 50kph (ish) seems to be the best way around it until the bug is patched.
Yes, I think so. Tried again last night. Drove the section in question at about 35-40 kph. No problem. Didn’t come across an active 500hz magnet. So it’s probably a gpa loop that’s set up wrong.