Hi everyone, does someone know what buttons to press or which steps to take when you accidentally triggered the emergency brake? I put everything back to normal - the brakes also- but the train does not drive again. :-/ Thanks in advance, guys!
I'm still new to rapid transit myself. But if I'm not mistaken, you have to reset the throttles back to its initial position and let the brake gauges reset. Make sure you have the indirect and automatic brakes released as well.
Thanks for your reply. ok I Think I actually did that but will check again. I thought you might have to reset SIFA or something. What do you mean by brake gauge reset? Until the brake pressure has gone?
You need to bring it back up to 0 the throttle and then reset the pantograph by raising it again and close the circuit of the pantograph PANTOGRAPH: Press the Pantograph Toggle switch PANTOGRAPH CIRCUIT BREAKER: Set the Pantograph Circuit Breaker to CLOSED Then you can carry on as normal
Hello GothicMatt! I apologise, but that is not necessary. You don't need to touch the Pantograph. Mr.Drew If you get a PZB Zwangsbremsung or if you accidentaly engaged EMG brakes do the following: 1) Independant brakes and Main brake control to 0. 2) If PZB Zwangsbremsung: When Vist < 30, Hold PZB Frei for 5 seconds. Now this hasn't been simulated correctly as of now, so just wait to a full stop and press PZB Frei. Should this get fixed, you know what to do. 3) Wait for the Hauptluftbehälter needle to fill to at least 8.3 bar. 4) Wait for the Hauptluftleitung needle to fall to at most 2.5 bar. Now you should be able to depart. If your Hauptschalter flew as in some TSxx addons, activate it again. Hope I helped Cheers, Prof. PS: Hauptluftbehälter = Main air reservoir Hauptluftleitung = Main air cylinder
Thanks a lot PZB Frei did the trick!! Btw. is there an option to zoom in temporarily on the buttons in the cab? I know you can select the screens but I thought that I have seen this zoom function in a video somewhere