Now this glitch can occur at any given point but I’ve noticed it happens most when you leave and go back in. The tilting on the front car works fine but the other cars don’t tilt. The only way to reset it is to stop the train and turn power and tilting off and on again.
This happens during the self test when you first switch it on but I've not seen it out on the road. Are you seeing it while driving tehangrybird345
Do you need to turn the fuse on in both trains? I personally haven’t and don’t recall seeing issue but could that be it?
I've had a similar problem yesterday on PC - the whole first unit and one car of the second one were tilting, the last car wasn't... until I switched the camera to the back, then it tilted to match the rest. While similar, mine is probably caused by some weird background setting in the LOD of the tilting animation, where it creates the animation to a certain distance that only covers 3 cars in the consist. Not sure if the same could be said about yours considering only one car tilted at all. Sidenote: shouldn't both parts of a 612 (and basically any tilting train) tilt together? Not independently? The angle between individual cars stays the same throughout the curve. Can't imagine crossing between them when one is tilting and the other isn't.
I've experienced the same, and zooming/closing in corrected it. Most settings arre on ultra (PC though), but one or two times, the rear car doesn't tilt until closer, then suddenly it follows the first.
Each car starts to tilt as it enters the curve indipendently, the moment the car starts to tilt is crucial for you not to feel dizzy Look from 2:15 to 2:40, and from 7:22 to 7:27 of this video showcasing the (then) new Pendolino
I don't think the draw distance from INI affects the trains or track, they're set after the INI is loaded.