Harlem Line Bug :p Stuck In Traffic

Discussion in 'TSW General Discussion' started by Ogs19, Mar 18, 2022.

  1. Ogs19

    Ogs19 New Member

    Joined:
    Oct 14, 2020
    Messages:
    11
    Likes Received:
    8
    Apologies if there is a already a thread for this. i encountered a rogue train on my timetable. i was playing the 05:56 Train 2307 GCT to Crestwood. it made for an interesting drive as i didnt want to plow into the back of it, however i tried to couple up to hitch a ride but it didnt work, i eventaully derailed when i found it again at a station while i was doing 56MPH :P

    I upload_2022-3-18_14-0-39.png
    upload_2022-3-18_14-40-57.png
     
  2. Anthony Pecoraro

    Anthony Pecoraro Well-Known Member

    Joined:
    Dec 11, 2016
    Messages:
    3,711
    Likes Received:
    4,323
    This is why you have to drive to what ATC tells you.
     
  3. HaibaraHariko

    HaibaraHariko Active Member

    Joined:
    May 23, 2019
    Messages:
    228
    Likes Received:
    188
    When ATC says "R", you should be under 15 mph. Just looking at the signal is not enough on this route.
     
  4. Inkar

    Inkar Well-Known Member

    Joined:
    Dec 13, 2016
    Messages:
    1,417
    Likes Received:
    2,335
    You are going too fast. Your speed should be below 15mph because the "R" is lighted up in the dashboard. You will probably want to read this short article that explains what each of the restrictions translates to in terms of speed.
     
  5. Ogs19

    Ogs19 New Member

    Joined:
    Oct 14, 2020
    Messages:
    11
    Likes Received:
    8
    thats quite cool if thats the case, not used to that system, id of presumed it was a bug, normally youd be held at a red, thank you :)
     

Share This Page