Ecw Double Trouble Scenario Stuck

Discussion in 'TSW General Discussion' started by morph147, Apr 1, 2022.

  1. morph147

    morph147 Active Member

    Joined:
    Feb 21, 2021
    Messages:
    113
    Likes Received:
    85
    Tried this scenario a couple of times now. After getting to Lewes I turn off the front car and then move to the back and uncouple. However what is happening after I leave Lewes is the first train is getting stuck at a red light forever where the eastboune and seaford paths divveage and I can’t get around. Any helps on this or is this a bug that I can’t get around.

    i did see one spot in forums mentions to turn off safety stuff, so I am double checking that first car has AWS switch set to isolated? I am not sure if this is considered off though?
     
  2. septafan

    septafan Active Member

    Joined:
    Oct 31, 2019
    Messages:
    159
    Likes Received:
    161
    I had this issue a long time ago the way i got around it was i ran very early on the schedule and when i uncoupled that's when the lead train ran its course with no issue.
     
  3. morph147

    morph147 Active Member

    Joined:
    Feb 21, 2021
    Messages:
    113
    Likes Received:
    85
    So if I am understanding you correctly, get to Lewes early and uncouple?
     
  4. morph147

    morph147 Active Member

    Joined:
    Feb 21, 2021
    Messages:
    113
    Likes Received:
    85
    Tried arriving early to get car going with no luck. I also know safety systems are off here so not sure where to go from here
     
    • Like Like x 1
  5. septafan

    septafan Active Member

    Joined:
    Oct 31, 2019
    Messages:
    159
    Likes Received:
    161
    Yes! That's what i did and the A.I went the proper route.
     
  6. arek#2842

    arek#2842 Well-Known Member

    Joined:
    Mar 1, 2022
    Messages:
    479
    Likes Received:
    506
    Do you mean you turn off the engines of first car or you just set reverser and master key to off position? I'm asking because AI is unable to turn on the engines of previously shut down unit.

    Yep, isolated means it's turned off.
     
    Last edited: Apr 2, 2022
  7. morph147

    morph147 Active Member

    Joined:
    Feb 21, 2021
    Messages:
    113
    Likes Received:
    85
    Reverser and master key only. It seems to get hung up on the uncouple step because I do it too quickly. Was uncoupling about 2-3 minutes early to try to get it to go.
     

Share This Page