Xbox N Wagen Needs Additional Info On Stalling Out Restarts?

I have experience several times where the n wagen will stall out or won't power up after stoping,i have tried resetting the controls which helped but only after many tries occasionally .So just how do you restart if you stall and how do you avoid over amping the motor which might be part of the problem.

 

Make sure that you always stay below 65kN, otherwise the main circuit breaker will pop out in the 110.

 

So if you over amp it,you have to reset the 110 CB to get the n wagen to restart?(btw wheres this CB?)
Also what guage shows this kn reading?

 

Put the throttle lever to 0, wait for the tap changer being in tap 0 (HUD shows that where normally the throttle position gets shown). Switch on MCB again. And you are fine to go again.

EDIT: for a rough idea: try to never reach the 2t point on the most right vertical gauge and you are good. The scale is useless normally, as it shows not the correct values (not even IRL). So stay under 2 and you are fine. Going over 2 might cause the MCB to pop.

 

Exactly, just stay below 65kN and you won't have any problems.

 

The 3 little bars on those gauges are not there on my xbox one version.So im guessing you need to use the onscreen hud but which onscreen hud is used to indacate that one the one with the 65kn?

 

The right bar, the actual kN are shown in yellow numbers (15kN in my picture).

 

Do you mean do this in the 110 or the n wagen?