PC Slippery Bakerloo Rails

I've been going back to the Bakerloo route for a bit of a change, and I'm struggling with traction underground on one of the journeys. Specifically I'm getting wheelslip when starting in notch 1, which is sometimes all the way up to 10mph. Doesn't sound a lot, but over a full run it adds up.

Worse though was fully locking up in brake notch 6 and going through a red light as a result.

Neither of these things have happened preivously - being deep underground, surely this couldn't be to do with surface weather/temp conditions, could it?

 

Not a problem at all. notch 2 until 10mph, then go into parallel. For braking approach the platforms at 30mph, and brake into notch 2, then back to 1 for the last bit.

Fast approaches like kilburn park you need to go into notch 3, then back to notch 2, then 1.
Brake above notch 3 is the lap of the westinghouse brake. notch 5 is the application of the westinghouse, notch 6 is emergency.

 

So this is all what I normally do - and it works fine. But for some reason, this one journey service I'm slipping like it's a skating rink... really weird.

 

Could it be that your train is not touching the rail with the powershoes? There are some positions with gaps

 

I’ve just gone onto tsw to try a service from elephant and castle to Queen’s Park, 1 with clear skies and one with rain. I can confirm that even if you are in the tunnels, wheelslip will still be the same as if you were outside

 

That's a shame - but thanks for letting me know.

 

I'd recon this is hard to simulate properly anyway, you could still slip underground if the wheels are wet after a rainy day.

 

I don't think anyone asked to go that far. We do not need an extremely complex simulation that considers how many particles of water remain in each wheel or each rail. Something far more simple like considering the rails and wheels are wet when they are under the rain and completely dry when they are not under the rain is good enough for most of us.

 

No, it isn't, because you WILL slip with wet wheels underground, the current implementation would be more realistic then.

 

Nope, because your wheels will be wet even if you never went outside.

 

It is very possible to get your wheels wet if you have a train ahead of you with wet wheels.

Anyway, I said that it would be more realistic than if wet tracks didn't exist underground, which it is.

 

That is your opinion. Mine is different. Lets agree to disagree.

 

It's not subjective. Wet tracks exists underground...

 

Instead of opinion let’s use science- if all the trains outside in the rain go inside, the water won’t just magically disappear, it’ll be carried onto the rails underground

 

Using the word "science" as a way of trying to validate your point of view is not scientific at all.

Water does not magically disappear, but also water that falls on the first section of track inside the tunnel does not magically go back to the train to fall over the next section of track, etc ... The rails 5 stations away from the entrance will not be as wet as the first one.

None of the simplifications of reality we are talking about exactly represents what happens in real life. Which of the simplified models feels more realistic to you is totally subjective.

 

No, it will for a long distance, and you can't just throw it in full service during that window. I've slipped half an hour later after being outside. I've slipped coming out of sidings on wet tracks other trains caused.

 

Painfully obvious that you don't know what you are talking about...

 

Even overground, another aspect isnt simulated are the leaves on tracks. There were bad accidents because of this (also a reason the rhtt is in use). Also tracks underground could get wet from air condition, temperature & winds etc, also im sure the brakes behave differently in the tunnels when coming right from a storm with the entire bogie being full of water, still in the brake system for a while. A Simulation of all this wouldnt be linear in any way.

But for me bakerloo even now is totally fine, nevery had a problem to brake (and im keeping the a.i timings no HUD). I dont think we need a macroparticle simulation , nor the leaves, so if they want to change something for unhappy players now, then just make the change at the tunnel border before entering undergound after queens park.

 

Abort abort...!

 

One train won’t drag water a long way into the tunnel, but the high intensity of the London Underground means that water will be carried quite a way

 

That I can agree on.

Unfortunately, nothing will change, including the vipers, that still are absurdly loud after all these years.