PC Power Line, Massive Air Leak

Discussion in 'TSW General Discussion' started by jjthomas, Mar 9, 2019.

  1. jjthomas

    jjthomas New Member

    Joined:
    Feb 22, 2019
    Messages:
    4
    Likes Received:
    0
    It starts after I connect to the two locomotives at E E06. I've played the scenario twice with the same result, whatever is leaking air runs the air down to zero. (Thank you for working hand brakes). I've double checked and triple check the various settings, MU2A valve to Trailer 6-26, three-way valve to cutout.

    I found that if I disconnect the 2nd locomotive I picked up at E E06, the hissing (air leak) stops.

    Is there a step I missed? How do I fix this?

    Thank you.

    -JJ
     
  2. Anthony Pecoraro

    Anthony Pecoraro Well-Known Member

    Joined:
    Dec 11, 2016
    Messages:
    3,711
    Likes Received:
    4,323
    Move the three way valve to freight and then back to cut out on all trailing locomotives. That will stop it. However, this issue might be fixed with a the new physics.
     
    • Helpful Helpful x 1
  3. Daniel Bloch

    Daniel Bloch Well-Known Member

    Joined:
    Dec 14, 2016
    Messages:
    649
    Likes Received:
    1,414
    Its more a initial problem at the scenario start then a physics problem, the switch is only visualy in the correct position. I think DTG could fix that scenario easily if they wanted.
     
    • Like Like x 1
  4. jjthomas

    jjthomas New Member

    Joined:
    Feb 22, 2019
    Messages:
    4
    Likes Received:
    0
    Thanks for the replies. I finally was able to finish the scenario. Eventually, I lost all air. I ended up setting the braked handle to emergency and then back to release.

    New Physics?

    -JJ
     
  5. Anthony Pecoraro

    Anthony Pecoraro Well-Known Member

    Joined:
    Dec 11, 2016
    Messages:
    3,711
    Likes Received:
    4,323
    Yes, they are working on fixing the physics of the CSX rolling stock.
     

Share This Page