I’ve just competed a scenario (Californian Commuter) fine and then went into timetable mode but I just cannot get the F40PH moving. I think I’m setting the loco up correctly, all brakes are released and it’s set to forward but once the doors are locked and I apply power it doesn’t move. It feels like there is a brake holding me back as when I open the throttle fully to notch 8 it’ll creep forward to 0.02mph before going back down to 0.00mhp. Anyone care to offer some assistance.
Service mode locos now start as they would be found by a new engineer coming on board. That means: The three engine switches on the main control stand are off, this locks out the throttle - turn them on. Brakes are cut-out, cut them in (rotate knob) and release brakes accordingly.
Thanks Matt, appreciate the response, got it up and running now. Thanks for the hard work on this DLC, I’m loving it.
