Pennisula Corridor

Discussion in 'Troubleshooting' started by larrycv43, Aug 19, 2019.

  1. larrycv43

    larrycv43 Member

    Joined:
    Jul 5, 2019
    Messages:
    37
    Likes Received:
    29
    Anyone else experiencing the Cab Car and the F40 just shutting off on you in a run? I have the alerter's off and the engine power just shuts off. I have not gone into emergency as well. I can't restart the engine or the cab car. All my pumps are still in the on position as well.
     
    • Like Like x 2
  2. TrainSim-Dmitri

    TrainSim-Dmitri Well-Known Member

    Joined:
    Jan 4, 2019
    Messages:
    973
    Likes Received:
    3,127
    Hi, if you move the throttle lever on the F40 below the idle position then it will shutdown the engine. The lowest position you can stay is idle without the engine stopping.
     
  3. larrycv43

    larrycv43 Member

    Joined:
    Jul 5, 2019
    Messages:
    37
    Likes Received:
    29
    Thank you! So to re-start the engine, I need to shut all the pumps down and pull out the reverser handle and re-start the engine?
     
  4. Matto140

    Matto140 Well-Known Member

    Joined:
    Oct 11, 2017
    Messages:
    602
    Likes Received:
    786
    Just set isolation switch to START/ISOLATE, press Engine Start Button.
    When engine starts set isolation switch to RUN, and continue driving.
     
    Last edited: Aug 20, 2019
    • Like Like x 2
    • Helpful Helpful x 1
  5. riveraamark

    riveraamark New Member

    Joined:
    Aug 19, 2019
    Messages:
    6
    Likes Received:
    5
    • Like Like x 1
  6. larrycv43

    larrycv43 Member

    Joined:
    Jul 5, 2019
    Messages:
    37
    Likes Received:
    29
    Thank you all!
     
  7. riveraamark

    riveraamark New Member

    Joined:
    Aug 19, 2019
    Messages:
    6
    Likes Received:
    5
    you're most welcome Larry :)
     

Share This Page