So today I purchased Luzern-Sursee, and I really enjoy the route. However, I have caught quite a few issues during my initial experiences. I shall list them below. Feel free to comment on bugs that were not included in this post. Horn does not sound in free-fly camera mode The first bug that I noticed on this route is that if you are in free-fly mode, the horn does not sound. Other exterior cameras work just fine, but when you are in free-fly mode, the horn does not sound. When moving the speed selector down, it moves the reverser as well This issue applies to anybody who uses classic controls for consoles. Whenever I want to reduce the speed on the speed selector, it also moves the reverser with it. If I am moving, it usually moves the reverser into neutral. If I am stopped, it always goes into reverse. Then I have to reset the safety systems since changing directions disables ETCS. ETCS not working? Now I am no expert with ETCS, but I believe that there are some issues with the safety system. Half of the time it works just fine, I get the beeping notification that I need to begin to slow down, and then a few seconds later the braking curve begins. But in some instances, you get no warning, and the speed curve goes drastically down, causing a penalty brake. I would assume that this is not supposed to happen. If I am wrong, feel free to let me know in the comments. ETCS disabled and speed selector set to 40 when loading a save game Halfway through a run to Sursee, I was going 160kmh and had all safety systems on. I had to leave so I saved the game. However, when I loaded up the save game, it set the speed selector to 40kmh, and ETCS was fully disabled. These are the current bugs that I have encountered on this route. If you have encountered issues with this route that I did not mention in this post, feel free to post bugs in the comments. Thank you
I bought it a week ago, am on PS4 but I don't think the issues are platform-related. I'm still learning ETCS so cannot comment on that. Horn does not sound in free-fly camera mode Same here. AI trains have no driver A lot (all?) of the AI trains drive around without a driver. Kinda ghostly and breaks the immersion. AI trains drive with only front lights on Front lights are on, but not rear lights. AI trains light front lights on rear side Contuing the above, depending the direction of the train, the front lights may be lit on the rear side of the train, and the front side is completely dark. Train from Luzern to Sursee: only front lights on, on front of train. Rear is dark. Train from Sursee to Luzern: Front is dark, front lights lit on rear of train. AI trains drive without outside destination signs Sometimes they are active, and sometimes they are completely blank. Passengers walk through doors Before the doors open, a little board slides out towards the platform. That takes a few seconds, during which the doors remain closed. Passengers don't wait to board the train until the doors have opened, they walk right through the still closed doors.
It is an attractive line ・Night is too dark ・Some signals turn off the light ・The dancer that a driver is weird
