Cannot Enter Cab In Tutorials

Discussion in 'Troubleshooting' started by imcp3137, Jan 10, 2019.

  1. imcp3137

    imcp3137 New Member

    Joined:
    Jan 10, 2019
    Messages:
    1
    Likes Received:
    0
    I go through the tutorials until I get to the part where I am told to climb into the cab.
    Nowhere in the tutorial is the Command key given for entering nor does it come up visually.
    The only time that I can get into the cab is go the Services panel and begin a task there. And the only way I get into the cab is to use Command 1.
    In the tutorials the camera views are not available so I am stuck outside the cab. Which makes learning extremely difficult.
    Please help
     
  2. xD 2Bad4You

    xD 2Bad4You Well-Known Member

    Joined:
    Mar 10, 2018
    Messages:
    1,002
    Likes Received:
    822
    It would probably help to include in which Tutorial and Route it happens. Makes it easier for people to check.
     
    • Like Like x 1
  3. eiamw

    eiamw New Member

    Joined:
    Dec 26, 2018
    Messages:
    21
    Likes Received:
    1
    I think pressing E gets you up the steps.
     

Share This Page