For some reason, the brakes wouldn't release and I was unable to move, after stopping at a station. Did absolutely nothing other than open and close doors. Train refused to budge no matter what I did.
I had the same thing with an 802. Expect my brakes did release but the train wouldn't move at all. Im on Xbox series S.
I remember when I first tried the 802 and when stopping at a red (can't remember if station or not) it wouldn't move after after setting and unsetting the DRA. Never tried using the DRA on it since
Think I had this once and ended up having to finish the run driving from the rear cab using external view. Was noted in the feedback thread at the time, doesn’t look like DTG bothered to fix it. Route and train probably already in the forgotten corner so far as they are concerned.
I have been complaining about the DRA for ages on the 802, amongst other things. Disables the cab permanently if you touch it Also all sorts of problems with only being able to fire up the diesel from one end, plus tail light labelling and some other bits and pieces. I don't hold out much hope for a lot of it, but if they can't be bothered to even fix the DRA which works fine in every other relevant loco and fine on the 801, of which this is basically a copy and paste job, then i really don't know what the point is anymore.
Did you hit the brake hold button accidently? It sticks on with this train for some reason, rather than being a hold and release like others and I have fallen foul of that before. The only other thing is opening and reclosing doors, as I have found the occasional glitch whereby the interlock does not get triggered properly and needs to be 'reset'.
