PC Crr Service Extra 3012 Setup

Discussion in 'Troubleshooting' started by Rudolf, Apr 17, 2021.

  1. Rudolf

    Rudolf Well-Known Member

    Joined:
    Dec 9, 2016
    Messages:
    2,488
    Likes Received:
    3,270
    Service 3012 runs a mainline loaded coal train of about 5000 tons. It has four F& units at the front and two SD40s as helpers at the back.
    The first SD40 should have the MU valve set to lead or dead, but it is set to trail 6 or 24. This is unusual, normally in timetable mode you only need to set the lead engine.

    I got the train running and initially it increased speed till 16mph, but, while the grade became a bit less steep, speed dropped back to 10mph, with power set in notch 8.

    So something is wrong, might it be that banking is not implemented correctly as well? I have no idea, but like other players I could not locate a control to activate banking. Here a gain the lack of a manual does not help and to be honest, this does not increase my happiness with this route.
     
  2. solicitr

    solicitr Well-Known Member

    Joined:
    Jun 20, 2020
    Messages:
    11,736
    Likes Received:
    17,949
    Banking apparently is not implemented at all in CRR, unless there is a Mystery Procedure that can be found in the manual.
    Which doesn't exist.
     

Share This Page