Dispolok 182 Doesn't Reset After Emergency Brake

I was doing Gaining Mass Scenario on SKW and i was indicated to stop at Signal G 303 and i was asked to contact Signaler so i did and was cleared to proceed at restricted speed so i tried to go past signal with PZB override pressed. but i was hit with emergency brakes.



Now after trying all possible things to reset emergency brakes, but the train just doesn't want ro reset, all it does is continuous buzzing. Now i'm stuck with no progression due to this error. now i have to cancel this mission and restart it.

I have Pressed PZB Release, Reset Brakes and increase Throttle but all it does is continue buzzing

 

You have to release and acknowledge.

 

^This. Holding release doesn't relieve you of the requirement to acknowledge the signal.

 

yes problem is not acknowledgement, problem is having traction lock and buzzing and literally can't move. Emergency brakes are not resetting.

 

Have you made sure to close circuit breaker? On some locos, this can happen

 

yes. even tried panto low and raise and MC close and even turned off PZB, LZB and even tried reverser off and everything. and at some point it only showed 1000hz buzz reverser at Reverse and nothing at Forward

 

Could be a bug then. Did you fill out a support ticket or post in technical reports?

 

This scenario is buged

 

know about Support but what's technical report and how you do that?

 

Just wait until next update or longer
They know about this issue since before release

 

There's a technical report forum and you can post on there too if you want

 

Will do that. Thanks for help, if that's a known issue, I'll look forward for the update.

 

turn off afb and then should be ok