PC Gp38-2 Not Releasing Brakes Fully

Discussion in 'Troubleshooting' started by r3volol, Aug 31, 2020.

  1. r3volol

    r3volol New Member

    Joined:
    Aug 31, 2020
    Messages:
    5
    Likes Received:
    1
    I can't seem to get the GP38-2 brakes to release fully everytime I play. Not sure what I'm doing wrong. Here are the steps I'm taking to get started after loading up the scenario (Y104 - Car Switching):

    1. Insert Reverser
    2. Turn on Gen Field
    3. Set Cutoff Valve to Freight
    4. Set to Forward
    5. Release Auto Brakes
    6. Set Throttle to notch 1/2/3

    Train starts moving but BC is stuck on 27 no matter what I do. Am I doing something wrong?
     
  2. Maverick_ng

    Maverick_ng Active Member

    Joined:
    Jun 29, 2019
    Messages:
    156
    Likes Received:
    107
    There's a switch to your left close to the floor. It should be on "lead or dead" position.
     
    • Helpful Helpful x 4
    • Like Like x 2
  3. r3volol

    r3volol New Member

    Joined:
    Aug 31, 2020
    Messages:
    5
    Likes Received:
    1
    Ah, yup. That did it. Thanks!
     
    • Like Like x 1
  4. bobh#4803

    bobh#4803 New Member

    Joined:
    Feb 27, 2021
    Messages:
    4
    Likes Received:
    1
    Thank you !! That helped me as well !!!
     
    • Like Like x 1
  5. ninjatrek2891

    ninjatrek2891 New Member

    Joined:
    Mar 13, 2021
    Messages:
    10
    Likes Received:
    3
    Ah! that one isn't in the introduction:)
     
    • Like Like x 2
  6. DabSmacker802

    DabSmacker802 New Member

    Joined:
    Mar 1, 2022
    Messages:
    1
    Likes Received:
    0
    I almost uninstalled the game before I found this :D
     

Share This Page