DB BR 403 The texture used for the Leuchtmelder (e.g. “PZB” in the screenshot) is incredibly low-res and colours from neighbouring Leuchtmelder in the texture clip into others (see “PZB” LM below) When shown, the “PZB” text disappears when reloading the screen (by e.g. going into an outside camera) When shown, the “PZB/LZB” text changes to only “LZB” when reloading the screen (by e.g. going into an outside camera) The “G” LM does not display on the MFD the first time it is triggered, while it does on the HUD Here is the second time it is triggered where it now works: When shown, the “G” LM disappears when reloading the screen (by e.g. going into an outside camera) The “G” LM does not flash on the MFD when it does on the HUD Befehl 40 does not work DB BR 401 PZB does not react to the reverser correctly! (no screenshots or video provided, but if you compare how other trains’ PZB reacts to reverser movement in TSW to the BR 401 you will quickly notice what’s wrong) PZB should not be active in when the reverser is in Neutral or Off PZB should always be switching to a constant Vmax of 100km/h with 100Hz flashing in Reverse, and not only after shutting down the cab and turning it back on The texture used for the Leuchtmelder (e.g. “1000Hz” in the screenshot) is incredibly low-res and colours from neighbouring Leuchtmelder in the texture clip into others (see “PZB” LM below) When shown, the “PZB” text disappears when reloading the screen (by e.g. going into an outside camera) When shown, the “PZB/LZB” text changes to only “LZB” when reloading the screen (by e.g. going into an outside camera) The "G" LM, while flashing, should not do so by alternating it's visibilty but rather by displaying an inverse graphic The “S” LM does not does not display on the MFD, while it does on the HUD DB BR 442/766pbzfa I am aware these are AI only trains, but while PZB does work on them correctly the PZB buttons in the cab (Befehl, Frei, Wachsam) do not work at all
