Xbox Msb Spad Help

So I created a scenario on MSB from Aschaffenburg siding 106 to germunden siding 101 for a freight journey and as I was leaving the yard that you go through at first I got a red light so I stopped.

After a moment because there is no traffic I contacted the signaller who said proceed at restricted speed, yet when went past the signal I got a spad?

Is this a bug or did I do something wrong? After requesting permission to pass I had only accelerated to 4mph

 

Were you holding PZB Override as you passed the signal?

 

No I wasnt, I'm not sure what happened.

 

That is what happened. When you pass a red with dispatcher permission, you MUST hold down PzB Override until the loco is past the red signal (neutralizing the 2000-Hz magnet), or you get an immediate shutdown.

 

Thank you for replying and helping, still learning freight and the german safety systems

 

Wouldn't that just stop him? Not close the scenario with SPAD?

 

Hmmm. Good point.

 

im on xbox and the red lights stayed on forever