Need Help Connecting A Junction

Discussion in 'Creation Centre' started by Brickrail782, Jun 5, 2025.

  1. Brickrail782

    Brickrail782 Active Member

    Joined:
    Sep 22, 2018
    Messages:
    233
    Likes Received:
    77
    I'm working on a route, and one of the junctions is located on a turn. The junction won't "officially" connect with the track, and thus won't create the frogs alongside the rails.

    I've attached a couple of screenshots of what the setup currently looks like, and the Google Earth overlay imposed on top.
     

    Attached Files:

  2. mindenjohn

    mindenjohn Well-Known Member

    Joined:
    Aug 19, 2022
    Messages:
    585
    Likes Received:
    426
    It won't form a correct junction because you have a joint in the "straight" section (shows up as an inverted V in red). You must have a clean section to get a proper connection. Suggest you cut it back as far as you can without causing the same problem in the lead in switch then relay the "straight" and retry the one you are working on now.
     
  3. Brickrail782

    Brickrail782 Active Member

    Joined:
    Sep 22, 2018
    Messages:
    233
    Likes Received:
    77
    Thanks. I managed to fix one of them, but unfortunately it doesn't seem feasible to fix the rest of them, at least without putting some of the yard tracks uncomfortably close to the main line.
     

Share This Page