Hi guy, So I did the start of the new york route, they tell you how to brake and all that, but as soon as they say drive to this location I cant do anything. the train dont move at all. I have charged the brakes, locked the doors and put the controls into forward ect. help please Thank you
Are you on ACS-64 (Amtrak) or on M7 (LIRR)? A screenshot of your HUD could help us to see if your train setup its correct. Update: Assuming you are on LIRR M7 cab the procedures to move the train are: -Set the master key to ON. -Set the reverser to Forward -Set the master controller to Max Brake (that's important cause you can charge the brakes ONLY when the master controller is set on Max Brake [10 <- on your HUD]) -Now you can charge the brake, open/close doors, switch on/off headlights, etc -When you are ready to move, release completely the brake [0 <- on your HUD] and keep attention that the orange needle on your HUD is positioning to (0) release position / (BP) Brake Pressure, like in the screen below otherwise the train can't move.