After seeing that their was an update to passengers, I’ve noticed now that they all don’t disembark at the start stop (first board) now which is an improvement, however I’ve yet to see any board at stops Also on a 387 Brighton to Gatwick service all disembarked at Gatwick, and as non get on it was empty to Victoria my notice of this was on XSX and using a 377 and 387 on BML
Bakerloo is still running with empty trains and passengers still not boaring the trains. The other bugs like people getting stuck in front of the doors when getting off trains is there too.
I did small check of passanger loading and unloading behaviour before 1st departure (timetable): 1) LGV (my minimum-requirement-AI-improvement-metter). On both ends of this route ai disembark totally before departure, stations are empty. 2) DRA: In Dresen all AI disembark before departure (other end ok) 3) HMA: On both ends of this route, trains are empty, platforms are empty. 4) SKA: Koln Station - all AI disembark (Aachen seems ok) 5) ECW: Seaford and Lewes - all AI disembark, Brighton-all disembark before seaford. 6) LIRR: NYPenn (empty station) and Hempstead - all AI disembark. 7) HAR: GCT - empty train, empty station (White Plains seems ok) 8) NTP: On both ends of this route AI disembark (empty stations and trains) 9) TVL: On both ends of this route AI disembark (empty stations) 10)NECBP: Boston - deserted stations and empty trains (late passengers dont board) , (Providence seems ok AI remain in train) 10) HBL, DCZ, BML (all AI disembark at Gatwick) , PC - both end stations seem ok (AIs remain in train before departure, but stations are empty, PC-AI in depot train) I have only sehs and necbp from the new tsw3 routes so thats it. Beside this, on the middle stations I see improvement, AI load into the train, platforms seem better populated but not to the level of satisfaction.
I’ve just given up with the passengers. I don’t massively care about them anyway but it does make the world feel dead.
My brain resist to drive empty public transport vehicle (train, plane, bus) it just become meaningless...
DTG JD Is their Any information that this patch hasn’t gone out correctly, as it seems to have changed between minimal - nothing. Whereas it seems to state they were completely/mostly fixed. Full Changelog Core Fixed issues where passengers did not board or disembark from locos.
Been the same on Xbox aswell, if they didn’t all get off at the starter point… however when I done the run I tested, no one got off until that point, stops at Hassocks and Burgess hill (I think they were) had no one enter or leave, just everyone disembarked at Gatwick then effectively ECS to Victoria
Been flying around Bakerloo line couple of days and usually I find 1-3 passengers in total. I was curious what the f is going on. Did also one run yesterday on London commuter to gatwick airport and was totally empty running. Im on PS5
This was primarily focused a specific passenger behaviour from Linke Rheinstrecke, but can have implications on other routes too. Work is ongoing to improving it.
Personally I don't own any of your new tsw3 addons because of this empiness, check FB and Iinsta fan roups this emptiness and AI ridiculousity starts beeing widely echoed outside this forum.
It's been like this since the Rush Hour update was added. I don't expect every countryside station to be swarming with passengers but empty trains and empty stations is immersion breaking for me, I've rarely been on it since.
Against my better judgement I bought TSW 3...... and to be honest after staring with disbelief at the passengers on the Transpennine Route I would rather they weren't there to be honest.
