PC Peak Forest - All Mixed Up Scenario.

Discussion in 'TSW General Discussion' started by daveking8, Jun 9, 2023.

  1. daveking8

    daveking8 Member

    Joined:
    Dec 12, 2016
    Messages:
    77
    Likes Received:
    33
    Has anyone not been able to complete this scenario ? After two plus hours I arrived into Chinley through siding. I then reversed to the turntable siding and uncoupled seven vehicles, then pulled forward to the through siding as instructed. Then I was asked to reverse again to drop more vehicles. Problem - could not reverse because of a red signal. When I contacted the signaller, the message said " Denied. Your train appears to be off path " So I was stuck between two red lights - help !
    Thanks in advance.
     
  2. matt#4801

    matt#4801 Well-Known Member

    Joined:
    Apr 8, 2022
    Messages:
    5,659
    Likes Received:
    10,274
    I completed the scenario without an issue, one of the best the best scenario I've played in this game.
    Did you pull forward too much and/or were all points set correctly?
     
    • Like Like x 4
  3. Cael

    Cael Well-Known Member

    Joined:
    Jul 26, 2018
    Messages:
    716
    Likes Received:
    1,497
    I will try to finish the scenario tonight and let you know. I've had to save and exit while shunting in Peak Forest station.
     
  4. Cael

    Cael Well-Known Member

    Joined:
    Jul 26, 2018
    Messages:
    716
    Likes Received:
    1,497
    Finished the scenario after saving and loading multiple times, the shunting in Chinley went off without a hitch.
     
  5. phil.elliott

    phil.elliott Well-Known Member

    Joined:
    Aug 26, 2020
    Messages:
    478
    Likes Received:
    1,024
    If you get the "train is off path" message it usually means:
    1. You've gone past a green signal you weren't supposed to (eg if you don't stop in a station and the whole train goes past the signal at the end of the platform, you might be able to reverse back into the station, but the light ahead will now be red, because your train already passed it).
    2. You didn't follow the intended path, or the current pathing (ie how the points are set) is incorrect. You can sometimes fix this by returning to the point at which you were last "on path" or by playing around with various points in the yard to see if you can find the issue.
    EDIT: I completed the scenario without any issues, but I know there was quite a bit of points switching at various stages, including the last section, so I suspect that's where the problem lies.
     
  6. daveking8

    daveking8 Member

    Joined:
    Dec 12, 2016
    Messages:
    77
    Likes Received:
    33
    Thanks for your replies. I'm sure that I stopped at the correct place though. Will look at it again tomorrow. Cheers :)
     
  7. Cael

    Cael Well-Known Member

    Joined:
    Jul 26, 2018
    Messages:
    716
    Likes Received:
    1,497
    Do a save ~1 mile from each station, just in case you overshoot the stopping point or something goes wrong during the shunting. That way, you won't have to repeat the whole scenario.
     
  8. daveking8

    daveking8 Member

    Joined:
    Dec 12, 2016
    Messages:
    77
    Likes Received:
    33
    Repeated the scenario and completed it with a gold medal ! Once again thanks to everyone who replied :D
     
    • Like Like x 3

Share This Page