PC Rapid Transit Pis Stopped Working During Timetable Session

Discussion in 'Troubleshooting' started by Perks390, May 13, 2021.

  1. Perks390

    Perks390 Well-Known Member

    Joined:
    Dec 8, 2016
    Messages:
    274
    Likes Received:
    324
    Whilst running the 2021 timetable, the PIS boards stopping showing information mid way through. I'm not sure when this happened exactly but the services I operated were S1 1147, then on foot took over S1 1205. At some point during the second service, the PIS boards stopped working. I believe this to be more towards the end of the service, I didn't spot it until I finished the service at Leipzig Hbf. Not sure if anyone else has had a similar experience? I've raised a ticket on the support section too.
     
    • Helpful Helpful x 1
  2. Perks390

    Perks390 Well-Known Member

    Joined:
    Dec 8, 2016
    Messages:
    274
    Likes Received:
    324
    Turns out this was caused by some commands in the engine settings, I now no longer have any issues.
     
    • Helpful Helpful x 1
  3. Task

    Task Well-Known Member

    Joined:
    Mar 27, 2020
    Messages:
    323
    Likes Received:
    949
    Another problem with the PIS is:
    In the pictures shown in the stream there were intermediate stops that weren't on the map on the departure boards. In the released version, those stops are missing. What's the problem here? I looked into the Timetable and in the Station Directory and it looks like they were set up.
     

Share This Page