PC Sehs, Driver <> Guard Signal, No Noise & Tgv Ref In Manual

Discussion in 'Troubleshooting' started by flamingoodmedia, Feb 4, 2021.

  1. flamingoodmedia

    flamingoodmedia Member

    Joined:
    May 30, 2018
    Messages:
    34
    Likes Received:
    52
    Hello peoples, as the thread says, there's no noise from the driver <> guard signal when the button is pressed, not sure if that's by design or not.

    And as mentioned to the stream tonight, the route introduction in the SEHS manual refers to LGV and not SEHS.

    Small bugs persist with fault situations / signalling / safety for me, such as KVB around St Pan seeming not to function, on the scenario where you take the wrong road tunnel as a diversion I had repeated emergency stops enforced at the stop board just after Ebbsfleet despite getting a proceed aspect from the signaller & TVM authorisation. Some of these issues won't clear. Perhaps the worst case for me was running a KVB test mode via the button the KVM display whilst at St Pancras, I could not stop this alarm again even tripping the breaker off & on or resetting all controls and the train never did move. Otherwise this is a solid release it would seem :)
     

Share This Page