I downloaded the Spirit of Steam Liverpool Crewe over Christmas. When I started "The Tables Have Turned" I'm told to go to the turntable (done), align the far end with the loco (done), board the loco and put the reverser in 75% (done) BUT... the turntable then turns itself the wrong way round once I start reversing causing my loco to derail. If I get out and reset the table, it switches it round again once I start to reverse again. Also if I turn the table and get back in the loco with the table "backwards" (so my front is in the right direction) it'll flip it round again so I cannot get off the table front ways. Edit: to work around this first issue I disabled 'auto set manual junctions', once I got past the turntable I was able to couple up to the service. I got on my way until just outside the station where I was derailed by an invisible force. I am currently unable to complete this scenario due to its many faults in the programming.
