Steam Stuck At Red Signal Before Emmenbrucke Gersag Station(train Sim World 3)

signal stuck on red 1.1km before station, going towards Sursee, signal stays red at hours on end, doesn't give me any other info other than wait for signal to change, which doesn't happen, the AI trains seem to be getting through just fine, so i don't know what the whole issue is, i even stop before the red signal, because i don't want to pass it, and end up failing, i've even tried walking down the tracks to see what the issue is, but can't seem to figure it out for the life of me; even tried changing the direction of a few tracks, with no luck

 

#1 How did you start it (Journey, Service/TimeTable, On Foot)?

#2 If you did not start it on foot, please consider doing so.

 

how did i start the journey? was in the train driver's seat
2) start on foot as in? walk around each station on foot or?

 

a) In TSW3 go to

#1 To The Trains
#2 Choose a route
#3 Luren Sursee
#4 Time Table
#5 On Foot

b) Then select

#1 For Place Sursee

#2 For Time 07:45

#3 Season and weather is up to you.

c) Press the far right lower corner button, Get Started.

d) Walk to where train is and take a set as the driver.

e) May be asked if you want to do service, say yes.

f) May setup train while waiting for service to start.

--

 

wasn't letting me control the train at all for some reason

 

When I spawned on foot at that time, there was a train already there.

When I first tried to take over it, it was an earlier train (ex 7:15) but after a short time I could. For ex at 7:46



Be sure to set the master key to on,



reverser forward



panograph raised


and release the brakes otherwise the train will not go anywhere.

I often close the doors and go as soon as the passengers are loaded even when it says to wait until a certain time as long as the light in front of me is not red. This often works with most routes but this route (and as you can tell by my next screen shot) is not one of the exceptions.

 

The only red seen before the last station is because the service has not started yet, like duh!

The only reason I was denied other than that is I passed the green light after a stopping location. Opps.



But after that time shown that I was to load passagers, I was not denied anymore unless if I did that happened again at next station.

 

yup works now; i'll see how i do this time,whether i get stuck at any signals or not

 

seems to have worked; thanks for the help