So, when I setup the train at the start of this scenario as Per the instructions, I start my journey from Marseille to Avignon, then about 4 miles in I enter a tunnel and I’m promoted to change power mode. I simply then just coast to a halt. There must be a sequence of events. I did the tutorial again, but I just can’t seem to get power back after I hit the power change location. Anyone any ideas? Thanks
Make sure that you do power change procedure correctly: Close main Circuit Breaker (Press the main circuit breaker switch); Set the pantograph switch to Lower; Set Pantograph to LGV (When heading towards Aix and Avignon) or DC (When heading towards Marseille); Set the pantograph switch to Normal; Press the main circuit breaker switch; Rearm Circuit Breaker switch. That should do it