Steam The German Pzb System Flaw In The Game(游戏里的德国pzb系统缺陷)

根据zusi3游戏和PZB手册，在德国列车处于可缓解的PZB限制模式时，按压PZB缓解后，确认PZB-1000Hz磁线圈，列车PZB系统不会直接进入1000Hz限制模式，而是85/70/55灯闪烁和1000Hz指示灯亮起。但是在游戏中却出现与上述情况不同的现象，1000Hz限制模式缓解后，PZB直接跳转到1000hz指示灯亮起的限制模式。在这种情况下，若确认1000Hz前，列车车速就已经超45km/h，那么当玩家确认此1000Hz磁线圈后，PZB就会立即采取紧急制动。简而言之，PZB存在限制模式无法解除的BUG。
顺便提一下ICE 403列车电子显示器的PZB显示问题。在我多次比较zusi3与403类似的显示器后发现，TSW3的ICE 403显示器上的PZB缺少黄色的限速提示条，这将会导致玩家在无HUD的情况下，无法准确区分PZB是限制模式限速45km/h还是PZB限速85km/h。
还有就是限制模式解除后，电子显示器上的85指示灯不会继续闪烁。而游戏制作与此情况不同。
以上就是我在游戏过程中发现的问题，如果你能解决我以上问题我将不胜感激。
AI translation

According to the zusi3 game and PZB manual. When the German train is in mitigable PZB restriction mode. After pressing PZB to relieve relief, confirm the PZB-1000Hz magnetic coil. The train PZB system does not go directly into the 1000Hz limit mode, but the 85/70/55 lights flash and the 1000Hz indicator lights up. However, in the game, there is a different phenomenon than the above. After the 1000Hz limit mode is alleviated, the PZB jumps directly to the limit mode where the 1000hz indicator lights up. In this case, if the speed of the train is confirmed before 1000Hz, the speed of the train has exceeded 45km/h. Then when the player confirms this 1000Hz magnetic coil, PZB will immediately take emergency braking. In short, PZB has a bug that the restriction mode cannot be lifted.
By the way, the PZB display problem of the electronic display of the ICE 403 train. Found out after comparing Zusi3 similar monitors to 403 many times. The PZB on the TSW3's ICE 403 display lacks a yellow speed limit bar. This will make it impossible for players to accurately distinguish between a PZB limit of 45km/h in limited mode or 85km/h in PZB without a HUD.
Also, after the restriction mode is lifted, the 85 indicator on the electronic display will not continue to flash. Game production is different.
These are the problems I found during the game. I would appreciate it if you could solve my above problems.