Update On Taurus Route

Discussion in 'Technical Reports' started by como98ly, Nov 25, 2022.

  1. como98ly

    como98ly Member

    Joined:
    Oct 24, 2020
    Messages:
    33
    Likes Received:
    34
    So I finally managed to finish the dark start scenario. On advice of the community I played it in 64 bits this time and now the coupling worked!. Very well done scenario, kudos to the devs.

    Then the timetable on the 130 min downhill passenger run which ends in Yenice. I tried to drive on time and the first five stops I arrived early (just a bit early) but then all of a sudden the next stop I was 2 mins late and failed that stop. I drove an average of 60 so I should be on time but I wasn't. It went from bad to worse. At the end I was five minutes late: 130 min drive, no checkmark.

    I think the timetable is to tight on the last 3 stations. Or I miss something. As said I drove an average of 60 the whole route with peaks of 80 (which is way too fast in my feel) and I still got five minutes late.

    Man I love the route and loco but I hate it when I fail a scenario because of this.
     
  2. Reef

    Reef Well-Known Member

    Joined:
    Jul 27, 2018
    Messages:
    2,806
    Likes Received:
    1,817
    This is the third thread you've started on the Taurus route, please stick to one, no need for a new thread every time you have something to add about it.
     
    • Like Like x 1
  3. como98ly

    como98ly Member

    Joined:
    Oct 24, 2020
    Messages:
    33
    Likes Received:
    34
    There's also a 90 min. freight shunting scenario with one TIMED event. I shunted 1,5 hrs failed the time limit and failed the whole scenario.
    It plainly sucks. I want to enjoy the shunting, take time to see where to go, set swithes, have to couple VERY slow or I derail.....a time limit is NO fun.
    I just want to enjoy the loco, the scenery and the shunting. A time limit breaks that. please, please remove it from this scenario!
     
  4. torfmeister

    torfmeister Guest

    Sometimes a job has to be done. The train you assembled has to get moving :)
     

Share This Page