I have just loaded the push pull set with the DBR112 but I am trying to run the DVT end but after shutting down the DBR112 (transformer still on) but there is nothing when I apply power at the DVT end. I have switched off everything at the rear and everything on at the DVT but the DBR112 will not propel, what am I supposed to do to get it to work? The gauge arrow and zbr reacts to power but there is no current.
On the left display, it needs to read HS an and a blue column needs to appear there. Use the panto button to up the panto, then close the MCB and start the trainline.
Check if the brake cylinder still has some pressure on it even when your brakes are fully released. If so, press the "brake overcharge" button until the brake cylinder pressure is 0 and apply power.
