Adding Quick Drive To Route

Discussion in 'General Discussion' started by jetgriff, Dec 12, 2019.

  1. jetgriff

    jetgriff Well-Known Member

    Joined:
    Aug 14, 2019
    Messages:
    316
    Likes Received:
    424
    Someone asked about "Quick Drive" on my Derby - Man - Sheff route..so been looking at it, takes a bit of setting up and all AI and sidings have to be restocked, but better in the long run. Will add it to all my routes and upload to UKTS...
    .
    qd.jpg
     
  2. jetgriff

    jetgriff Well-Known Member

    Joined:
    Aug 14, 2019
    Messages:
    316
    Likes Received:
    424
    save me time searching, anyone know how I can get the route picture to show in the route box?
    Found it, just add "image.png" to route description
     
    Last edited: Dec 13, 2019
  3. jetgriff

    jetgriff Well-Known Member

    Joined:
    Aug 14, 2019
    Messages:
    316
    Likes Received:
    424
    TS Quick Drive, not as good as it seems, you have to have the route set by controller, sometimes wrong line and through yards.. you can "go via" a bit but then it routes all stuff via that mark.
    i.e from Sheffield to Manchester i have to create a 'start' from platform 5 and the Sheffield to Birmingham to 'start' form platform 6.
    Benefits are you only have to populate route with A1 traffic and sidings traffic once for all.
    Correct me if I am wrong, still learning.
    .
    Manchester via Hope Valley
    man.jpg
    .Derby Birmingham etc via Chesterfield

    brum.jpg
     
    Last edited: Dec 13, 2019
  4. USRailFan

    USRailFan Active Member

    Joined:
    Jul 2, 2018
    Messages:
    457
    Likes Received:
    125
    Isn't it in the RouteInformation subfolder, IIRC?
     
  5. jetgriff

    jetgriff Well-Known Member

    Joined:
    Aug 14, 2019
    Messages:
    316
    Likes Received:
    424
    yes thats it.. fussy about size of the piccy though,
     

Share This Page