In one of the scenarios "CUTTING CLOSURE" in the TSW 2020 East Coastway Route, setting up the cab, you are asked to release the brakes until the dial reaches a set figure (see figure below). There are two indicator markers but only one moves back to the release point. However, once you have released the brakes you cannot proceed any further as the scenario thinks the brakes are still applied. Is this a bug or idiosyncratic to my install? pH
This is a more complex scenario in someways, involving trips back and forth between both of the engines on this train. Did you set the brakes in the other engine correctly? You need to correctly set the brakes in both loco's before you'll be able to move.
Many thanks setting the brakes correctly fixed the issue watched a good video on YouTube explaining the procedure. pH