I rarely play CRR so I can't tell how common/known this issue is, but I encountered a bug with foliage and distant trees being either untextured...
Hello folks, Hope you've had a good week. We're coming into the penultimate week before Spirit of Steam's launch, and we have a whole glut of...
I think it is reported before, but please fix this. The stopping points in Elkhorn for mainline services is far to close to a signal, 2-3ft. This...
This issue concerns timetable service CRR97 Northbound Florida Perishable, departure 12:12. Shortly afeter departure from Dante, a coal train...
The signalling really needs to be addressed on CRR, This is the 2nd time I've come head to head with another train! This time I was on time & this...
Delano - Dante via Caney. There is a dispatcher error, the oncoming train from Dante should have been looped a mile or so ahead to allow me to...
Got CRR last night & had a heap of fun driving the F7, lots of entertainment had shunting with it too! 1 - What's the difference with...
Train 3001 Northbound cola is required to stop at a 1.5% downward grade with a fully loaded coal train at a distance of 3 ft from a signal at...
Hey, guys. I have a question. If you select a service, then pick the F7 youll see two services at the top. CRR Extra 3010 and 3012. If you play...
With brakes applied, gauge reads correctly, but when released, it reads 0. This seems wrong to me. What does red needle indicate and why isn't it...
If you start the game from a game save the state of th gauge lights is not restored. The setting is OK, but the light is not working. You need to...
I started the scenario (starts at 19:08) and it was pitch black, as it should be at 7pm in early February, but as soon as I moved forwards to the...
I've been poring through the EMD F7 manual. Came across this little gem in Miscellaneous Operating Instructions (item 208): Operation over...
I found an error in the "Limited power" scenario on CRR: When resuming from a save created just before splitting the train in two at the yard...
Clinchfield Railroad Journey (Service 1 of Chapter 2) You start with three SD40-2 but they don't have enough power to drive faster than 0.6 mph....
When you go on your way back after completing loading, you ned to change cabs. The instructions are not complete and miss two important aspects:...
Service 3012 runs a mainline loaded coal train of about 5000 tons. It has four F& units at the front and two SD40s as helpers at the back. The...
In CRR there is a lot of shunting the dark. Sometimes there is a little light left, but sometimes you can hardly see the end of the train. The...
I felt rather confused when playing the First Moss Turn Part 2 timetable drive. I was instructed to stop before Holly Creek siding to pick up 12...
In timetable mode for the F7 the cut-out valve is set to cut-in during startup. This may be intentional, but for all other US locos it is initial...
First of all: I know the PS4 isn't a PC and of course I don't expect it to run 60fps or more all the time! And so far I'm really impressed with...
When you drive over the CRR turntable it shows in the HUD like you are overspeeding. It happens at both sides of the turntable. Did someone forget...
I thoroughly enjoyed this scenario and am rapidly coming to the conclusion that Clinchfied has taken over my favourite route spot from Sand Patch....
For the SD40, when you start the bell you see the clapper move once and then it freezes. It is a small detail, but seen ...
For Fremont descend scenario you are instructed to set the selector lever in position 4. This should be position 1. I think for Fremont ascend you...
Blue Diamond
Every time I've run a timetable service with the SD40 on Clinchfield, I lose engine audio. At the start of the service, everything appears...
At McClure there is an unused SD40 engine. I coupled it to an empty hopper train and forward to load coal. It does not work. This is in contrast...
It is very minor, but: You are instructed to set units in position 2, which should be 3, it is an ABA configuration.
Hi I thought I'd try this service with the F7, to start off the Mastery challenge of loading 60 coal wagons. The loading is in two parts. The...
Does anyone know if the refer cars in this service are weighted? I opened one and they appear empty, however this train should be fully loaded...
Today I tried the McClure service part 1. A bit tp my dismay the train started rolling backward right away. Of course it was not setup at all....
When setting the start location for first person mode, the locations are sorted alphabetically, instead of in order of the map. This is very...
In the preview stream for the upcoming Clinchfield route, Matt revealed their new way of creating North American horns. This included recorded...
Separate names with a comma.
