1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Acs 64

Discussion in 'General Discussion' started by colsay, Jan 27, 2019.

  1. colsay

    colsay New Member

    Joined:
    Jan 27, 2019
    Messages:
    3
    Likes Received:
    0
    Can someone tell me how to close the cab door so I can access the battery button which is obscured when the cab door is open? Thx
     
  2. Canon772

    Canon772 Member

    Joined:
    Jul 24, 2018
    Messages:
    94
    Likes Received:
    61
    You do the same thing as you did to open the door. Place the cursor on the door (not the window) and when the message "cab door is open" appears, press X on the controller.
    This method is used for all locos.
     
  3. colsay

    colsay New Member

    Joined:
    Jan 27, 2019
    Messages:
    3
    Likes Received:
    0
    Canon772, thank you for your reply and advice. I did the tutorial again and by changing the viewpoint I could access the battery button and complete the setup.
    I tried placing the cursor on the door but there was no response. So, I sat in the seat , did the rest of the setup and drove off, thinking the door would still be open but when I looked round inside the cab it wasn’t. Must be a self closing door! ( in the tutorial at any rate).
     
  4. Canon772

    Canon772 Member

    Joined:
    Jul 24, 2018
    Messages:
    94
    Likes Received:
    61
    Sometimes it only seems to work on certain parts of the door. Alternatively, try changing your position in the cab slightly. If you keep trying, it should eventually happen.
     
  5. colsay

    colsay New Member

    Joined:
    Jan 27, 2019
    Messages:
    3
    Likes Received:
    0
    Tried as you suggest but nothing found. Having moved to the next scenario after the tutorial, it is the same. Walk to loco, open door, go through start up procedures and off it goes - and if you then look round the door has closed.
     

Share This Page