PC Boston Sprinter Scenario Planner - All Signals Stuck On Stop

Discussion in 'Technical Reports' started by mike.obrebski, Jan 3, 2022.

  1. mike.obrebski

    mike.obrebski Active Member

    Joined:
    Sep 3, 2021
    Messages:
    131
    Likes Received:
    94
    Just configured a single scenario.
    ACS64 with 2 coaches.. from South Station to Providence, stopping at every station. Unloaded, not a passenger service, so not need for door. Just wanted to take a ride down the route to note speed limits.
    Did not configure any other traffic.
    Leaving Platform, dwarf Stop signal.
    Contacted dispatcher, no effect, no message.
    Waited about 5 minutes.. light doesn't change.
    ATC shows, restricted, 10 and ACSES
    Passing signal fails scenario. Every signal on map indicates red.

    So basically cannot run a scenario out of South Station. Tried with various route combination and tracks.
     
    Last edited: Jan 3, 2022

Share This Page