Firstly, is there a Manual for this Loco anywhere on the Forum, I have seen there are a couple already in circulation for different locos already? If not could anyone help me after my little issue that is detailed delow. Had a go last night on WSR with the 52 scenario where you take the Railtour back to the mainline via the Norton Fitzwarren Triangle. When I started at Minehead, got everything set to go and decided to try and activate the TPWS. After going through all the dash switches and failing to find it, I then discovered the lever down the side of the Drivers Seat which was in the Unisolated position (arrow facing down), I also found the switch in the corridor behind the cab door which I set to the on position (labeled DSD I think). Everything set ready to go, released Brakes , applied Throttle to get going, then before I knew it Ear splitting alarm, little yellow ! in the HUD lit up and wouldn't turn off when I hit the Acknowledge button. This of course bought the damn thing to a complete stop!!! Managed to reset and then restart again only to get as far as the Level Crossing before it done the same thing again and wouldn't recognise the acknowledge button again!!! After deciding that it was broken, I disabled the switch in the corridor and managed to complete the journey, albeit late after the unplanned incidents at Minehead. Thanks for your helpful inputs and indeed advice on hoe to resolve this slightly annoying problem.