Signals & Track (fixed) Switching Track Direction?

Discussion in 'PC Editor Discussion' started by Tomas9970, Dec 5, 2023.

  1. Tomas9970

    Tomas9970 Well-Known Member

    Joined:
    Oct 7, 2018
    Messages:
    932
    Likes Received:
    890
    Hello. I have a simple but maybe a bit hard question. Is there any way to change the intended track direction?

    The OBB pre-signals I'm using seem to break if it's not set properly.

    edit: Ok I think I fixed all related issues though the method is unclear. Either it happened when I cleared the track section and re-generated them or it happened due to increasing the Adjacent Clearence Distance to a value higher than my 4.75 meter track spacing.

    Now I can happily run trains on both tracks in both directions.
     
    Last edited: Dec 6, 2023

Share This Page