I'm stumped. I've carefully run through all the start-up steps for this train's 195.2 engine (and run the tutorial multiple times), I cannot get the engine to move. This is the session in which a train made up of engines has to be driven to a stated destination. Do the non-driven engines require some kind of startup procedure?
If I recall, there's another multi-loco setup where the brakes need to be released in each cab separately before the lead loco can move. Perhaps this is similar.
Thanks to Gordon and Anthony for providing the correct information. I've now run this session successfully and enjoyed it thoroughly.
Thanks! This helped me a lot. I was completely stuck. Two of the parking brakes were of the manual kind and in the last three locos the battery needed to be powered on before the parking brake could be released. Now I need to get this train to it’s destination - I’m at least 30 minutes late! ;-)