When my rear brake pressure reached 60 and above im unabke to move the train and the throttle does not respond Any help?
First check that your stand is active. Engine, gen, fuel all switched on. Then check reverser, in and forward. If you have done that and you're still stuck, I have encountered a bug where the ES44AC's engine may shut off during setup, so this may be whats happening. Reverser neutral Independent full service Go to back wall, set isolation switch to start Hold engine start button (you should hear it prime) Release and hold again (you should hear engine start) Set isolation to run Reverser forward, brakes release, and you should be good. *just a note, since there isn't a manual, this is kinda my guess at the startup process, but it seemed to work for me.
I have noticed some of the trains seem somewhat light around 1200t when playing from timetable mode. Really like the route but this seems somewhat odd for a intermodal with helpers weighing 1200t