1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

PlayStation München - Augsburg Scenario Designer

Discussion in 'Technical Reports' started by flystentz, Nov 1, 2020.

  1. flystentz

    flystentz New Member

    Joined:
    Sep 17, 2020
    Messages:
    16
    Likes Received:
    12
    In the scenario designer when i set trains to run both ways on the high speed line, they use the same track so other trains are not driving past on high speed.

    [​IMG]
    Here i am going towards Munich


    [​IMG]
    Here im going towards Augsburg in the same track (the outer one)
     
  2. flystentz

    flystentz New Member

    Joined:
    Sep 17, 2020
    Messages:
    16
    Likes Received:
    12
    In my cuurent drive 2 trains from Augsburg are driving on the left track towards Munich, and one takes the right track towards Munich

    Then the one train i have set from Munich towards Augsburg are taking the right track, where 2 trains are going towards it
     
  3. Luke8899

    Luke8899 Well-Known Member

    Joined:
    Aug 14, 2020
    Messages:
    164
    Likes Received:
    340
    I have also encountered this using AI traffic. As mentioned above, only the outside HS track is used for traffic in both directions. It means one of the AI trains is held at a red until most of the line is clear of any traffic coming in the opposite direction.

    (Only in route created in the scenario planner)
     

Share This Page