I would like to recommend a control to disable the ending of a route after going past a signal at danger. Sometimes I’m either not paying attention or I go 3 ft too far when stoping. Yes, I know there’s a train probably in the next section of track, but the collision would be your fault. For example I had a cal train right behind my 30 car ish freight liner. If the signal would permit me I would have backed up and coupled to the cal train. I know not all people want this so that is why I think it should be an option for people who just want to drive trains and don’t give a crap about the signals. Another option I want would want is to continue after a collision. When I crash I don’t even get to see the aftermath or get out and do another service. I have to wait about 5 minutes in loading screens to start over. I know this might not be possible due to licensing but make it at least possible to go back maybe a mile or two or something so that you don’t have to restart from the beginning.