1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sraight Track Indicator Missing

Discussion in 'General Discussion' started by Sabe20189, May 24, 2020.

  1. Sabe20189

    Sabe20189 Member

    Joined:
    Apr 21, 2020
    Messages:
    59
    Likes Received:
    9
    I have been trying to lay a 6 mile stretch of track but for some reason when I install a section of rail, I should get a yellow indicator when the rail is perfectly straight but instead the section blinks out when it is straight rather than show the yellow indicator so I end up with a serpentine appearance instead of a long straight line.
     
  2. Buynot

    Buynot Well-Known Member

    Joined:
    May 5, 2018
    Messages:
    522
    Likes Received:
    1,212
    In my experience, this happens when snap to track is enabled. It can be disabled by unchecking it in the fly out menu on the bottom left of your screen.
     
  3. Sabe20189

    Sabe20189 Member

    Joined:
    Apr 21, 2020
    Messages:
    59
    Likes Received:
    9
    Thank you buynot. I have it now. I just layed a single straight track and slid it over the overly, squared it up on both ends and then layed about 4 miles right on target.
     
  4. Doomotron

    Doomotron Well-Known Member

    Joined:
    Oct 24, 2018
    Messages:
    484
    Likes Received:
    447
    <pedant>The yellow indicator can appear when Snap To Track is enabled, but only on very short sections of tracks.</pedant>
     
  5. Sabe20189

    Sabe20189 Member

    Joined:
    Apr 21, 2020
    Messages:
    59
    Likes Received:
    9
    Thank you.
     

Share This Page